Amico Satin Finish DISS Console Outlets

 
Features:

• Flow rate exceeds the requirements of NFPA and CSA
• Accepts only DISS gas specific adapters
• 100% Hydrostatic testing of each outlet and cleaned for medical gas service
• Indexed to eliminate interchangeability of gas services
• Up to 3/4” [19 mm] mounting plate thickness adjustment
• 360° Swivel Inlet Pipe for easy installation
• Universal Rough-In Assembly to accept Quick Disconnects or DISS Front Adapters (Can be interchanged at any time)
• Outlets are also available for M.R.I use

Request a Quote

 
General Specifications:
The medical gas outlet shall be an Amico Alert-1 series.

• Outlets shall be manufactured with a 6 – 1/2” [165 mm] length type “K” 1/2” [12.7 mm] outside diameter (3/8” nominal) size copper inlet pipe stub which is silver brazed to the outlet body. The body shall be of 1 – 5/16” [33 mm] diameter, one piece brass construction. For positive pressure gas services, the outlet shall be equipped with a primary and secondary check valve and the secondary check valve shall be rated at a maximum of 200 psi [1,379 kPa] in the event the primary check valve is removed for maintenance. Outlet bodies shall be gas specific by indexing each gas service to a gas specific single pin indexing arrangement on the respective identification module.
• A satin finish color coded front plate shall be used for gas identification and aesthetic appeal.
• With the back rough-in mounted, the outlet shall adjust up to 3/4” [19 mm] variation in mounting plate thickness.
• The latch-valve assembly shall be DISS type and only accept corresponding DISS type gas specific adapters.
• All M.R.I. outlets are manufactured from nonferrous materials.
• All outlets shall be cleaned and degreased for medical gas service, factory assembled and tested.
• The outlets are UL Listed and ETL Listed.
• Amico products comply with NFPA-99.