Amico Ball Valve with Extensions and Dual Purge Port
Features:
- 3 piece design for ease of maintenance
- 100% Hydrostatic tested
- Cleaned for medical gas service
- Blow-out proof stem
- Available in sizes 1/2” to 4”
- Full-Port design
- Dual port design
- Available in locking or non-locking
| Request a Quote |  |
General Specifications:
All purge port isolation valves shall be an Amico Alert-1 Series.
The Valve shall be 3 piece ball-type design with a bronze body and chrome plated brass ball for sizes 1/2” to 2-1/2”. A blow-out proof stem shall be used and the valve shall have a maximum pressure rating of 600 psi [4,137 kPa].
Valves shall be operated by a lever-type handle requiring only a quarter turn from a fully open position to a fully closed position.
Ball valves shall be equipped with type “K” copper pipe stub extensions at both the inlet and outlet sides of the valve port to facilitate installation.
Valves shall be designed in such a manner that it can be “swung-out” during installation so as to prevent damage due to heat transfer during the brazing operation.
Each valve assembly shall be washed and degreased for medical gas service. Pipe stub extensions shall be capped at both ends. The valve shall be supplied in a sealed plastic bag to prevent contamination prior to installation.
Amico products comply with NFPA-99, CSA Z7396.1 and CSA Z305.1.
- Medical Gas Zone Valves
- Amico Multiple Zone Valve Box Assembly NFPA-CSA
- Amico Multiple Zone Valve Box with Sensor
- Amico Security Zone Valve Box
- Amico Single Zone Valve Box Assembly NFPA
- Amico Valve Alarm Combo Unit
- Allied Half Inch to Four Ince Ball Valve
- Allied Half Inch to Four Inch Dual Port Ball Valves
- Allied Emergency Oxygen Connection Box Assembly
- Allied Zone Valve Box Assemblies
- Amico Ball Valve with Extensions and Dual Purge Port
- Amico Ball Valve with Extensions with Stainless Steel Ball and Stem
- Amico Ball Valve with Extensions for Manifold
- Gauge for Valve Box and Isolation Valve
- Amico Check Valve with Extensions